Kenwood DNX6040EX Zone Control, FREQ, LEVEL, [Flat], Q Factor, Continued, Bass DC EXT, ] (Rear VOL.), [Single Zone], Subwoofer Level, Audio Setting Up, 2 Touch [Dual Zone]

Controlling equalizer manually

1	Touch [Tone] in the Equalizer screen.
2	Set each item as follows.

FREQ

Adjusts the center frequency for each range. Setting values are as follows.

Bass: 40Hz/50Hz/60Hz/70Hz/80Hz/100Hz/120 Hz/150Hz (Default is “100Hz.”)

Middle: 500Hz/1kHz/1.5kHz/2kHz (Default is “1kHz.”)

Treble: 10kHz/12.5kHz/15kHz/17.5kHz (Default is “12.5kHz.”)

LEVEL

Adjusts the level of each range.

Each setting value is within -8dB and 8dB and default is “0dB.”

Q Factor

Adjust Q value for bass and middle.

Setting values are as follows.

Bass: 1/1.25/1.5/2 (Default is “1.”)

Middle: 1/2 (Default is “1.”)

Bass DC EXT

Turns Bass DC EXT on or off. Default is “OFF.”

If you select “ON”, the bass center frequency is extended to the low register by approximately 20%.

[Flat]

Tone level becomes 0 (flat).

Subwoofer Level

Adjusts the subwoofer volume. This setting is not available when subwoofer is set to “None”.

See Speaker setup (P.81).

Return to the Top page

Audio Setting Up

Zone Control

You can select different sources for both front and rear positions in the vehicle.

1 Touch [Zone Control].

Zone Control screen appears.

2 Touch [Dual Zone].3 Set each source as follows.[3] (Front Source, Rear Source)

Select the audio source for each. [∞], [5] (Rear VOL.)

Adjusts the rear channel volume.

[Single Zone]

Touch to turn off the dual zone function.

Continued

87