Kenwood MDX-01 48 EN, Execution, 7Execution, "PROG. 2") is lit, 7PresstheVOLUME/MULTICON, 8PresstheVOLUME/MULTICON, 0PresstheVOLUME/MULTICON, Program timer (continued)

Program timer (continued)

7PresstheVOLUME/MULTICON-

TROL UP () or DOWN ( ) key to select "PLAY" or "AI PLAY", thenpresstheSET/DEMOkey.

"PLAY" : The source will played at the adjusted volume before entering the STANDBY mode.

"AI PLAY" : The playback volume will increase gradually after the start of timer playback.

8PresstheVOLUME/MULTICON-

TROL UP () or DOWN ( ) key to select the music source to be input, then press the SET/ DEMO key.

The input source can be selected from "CD", "MD" and "TUNER" (radio).

9To listen to radio broadcast-

ing, press the VOLUME/MULTI CONTROL UP () or DOWN ( ) key to select the preset number ofthedesiredstation,then press the SET/DEMO key.

This operation is not required when an input source other than "TUNER" is selected.

0PresstheVOLUME/MULTICON-

TROL UP () or DOWN ( ) key toadjustthelisteningvolume.

The source will be played at the adjusted volume.

This step is not required when "AI PLAY" is selected.

7Execution

!Press the TIMER key on the remote repeatedly so that the program number to be executed ("PROG.1" or

"PROG. 2") is lit.

Program No.

@Press the POWERkey to put the unit in the STANDBY mode.

When the timer program is activated and the unit enters the STANDBY mode, the STANDBY/TIMER indicator lights in green. When the set ON time comes, the timer program is executed and playback starts.

To cancel program timer :

Press the TIMER key on the remote so that "PROG.1" and "PROG.2" are not lit.

To check or change the timer setting :

Restart the procedure from step 1 again.

÷Be sure to adjust the time of the day (page 10) before using the timer functions.

÷The program timer cannot be used for program playback of CD or MD.

÷PROG.1 and PROG.2 should be set so that their operating periods do not overlap. Leave at least 1 minute of interval between the two programs.

÷The program timer setting is held in memory even after it is canceled. The program timer setting remains in memory unless it is newly set again.

÷If the STANDBY/TIMER indicator is blinking in green, the timer setting may be erroneous or the time of the day is not adjusted. Re-set the appli- cable item.