PRECAUTIONS

Please observe the following precautions to prevent fire, personal injury, and transceiver damage:

¥Connect the transceiver only to a power source described in this manual or as marked on the transceiver itself.

¥Route all power cables safely. Ensure the power cables can neither be stepped upon nor pinched by items placed near or against the cables. Pay particular attention to locations near AC receptacles, AC outlet strips, and points of entry to the transceiver.

¥Take care not to drop objects or spill liquid into the transceiver through enclosure openings. Metal objects, such as hairpins or needles, inserted into the transceiver may contact voltages resulting in serious electrical shocks. Never permit children to insert any objects into the transceiver.

¥Do not attempt to defeat methods used for grounding and electrical polarization in the transceiver, particularly involving the power input cable.

¥Adequately ground all outdoor antennas for this transceiver using approved methods. Grounding helps protect against voltage surges caused by lightning. It also reduces the chance of a build-up of static charge.

EXAMPLE OF ANTENNA GROUNDING

 

ANTENNA

 

LEAD IN

GROUND

WIRE

CLAMP

ANTENNA

 

 

DISCHARGE UNIT

 

GROUNDING

 

CONDUCTORS

ELECTRIC SERVICE

GROUND CLAMPS

POWER SERVICE

EQUIPMENT

 

GROUNDING ELECTRODE

 

SYSTEM

¥Minimum recommended distance for an outdoor antenna from power lines is one and one-half times the vertical height of the associated antenna support structure. This distance allows adequate clearance from the power lines if the support structure fails for any reason.

¥Locate the transceiver so as not to interfere with its ventilation. Do not place books or other equipment on the transceiver that may impede the free movement of air. Allow a minimum of

10 cm (4 inches) between the rear of the transceiver and the wall or operating desk shelf.

¥Do not use the transceiver near water or sources of moisture. For example, avoid use near a bathtub, sink, swimming pool, or in a damp basement or attic.

¥The presence of an unusual odor or smoke is often a sign of trouble. Immediately turn the power OFF and remove the power cable. Contact a KENWOOD service station or your dealer for advice.

¥Locate the transceiver away from heat sources such as a radiator, stove, amplifier or other devices that produce substantial amounts of heat.

¥Do not use volatile solvents such as alcohol, paint thinner, gasoline or benzene to clean the cabinet of the transceiver. Use a clean cloth with warm water or a mild detergent.

¥Disconnect the input power cable from the power source when the transceiver is not used for long periods of time.

¥Remove the transceiverÕs enclosure only to do accessory installations described in this manual or accessory manuals. Follow provided instructions carefully, to avoid electrical shocks. If unfamiliar with this type of work, seek assistance from an experienced individual, or have a professional technician do the task.

¥Enlist the services of qualified personnel in the following cases:

a)The power supply or plug is damaged.

b)Objects have fallen or liquid has spilled into the transceiver.

c)The transceiver has been exposed to rain.

d)The transceiver is operating abnormally or performance has seriously degraded.

e)The transceiver has been dropped or the enclosure damaged.

¥Do not attempt to perform any kind of configuration or menu setup configuration while driving your car.

¥Do not wear headphones while driving.

¥Install the transceiver in a safe and convenient position inside of your vehicle so as not to subject yourself to danger while driving. Consult your car dealer for the transceiver installation to ensure safety.

¥HF/ 50 MHz mobile antennas are larger and heavier than VHF/ UHF antennas. Therefore, use a strong and rigid mount to safety and securely install the HF/ 50 MHz mobile antenna.

iii

Page 5
Image 5
Kenwood TS-480SAT, TS-480HX instruction manual Precautions