3 GETTING ACQUAINTED

LCD DISPLAY

q w

e

r t y u i o!0!1 !2 !3!4!5!6 !7!8!9

qMETER

While receiving, serves as an S-meter to measure and display the received signal strength. While transmitting, serves as a power meter plus an ALC meter, an SWR meter, or a Speech Processor compression meter. The Peak Hold function holds each reading for approximately half a second.

wRtATsT

Appears while the internal antenna tuner {page 60} or an external antenna tuner is in-line for the operation.

e1tANTs2

Either Ò1tANTÓ or ÒANTs2Ó appears, depending on which antenna connector is selected for the operation {page 60}.

rATT

Appears when the receiverÕs attenuator (approx. 12 dB) is ON {pages 49, 61}.

tPRE

Appears when the receiver pre-amplifier (approx. 6 dB) is ON {page 49}.

yVOX

Appears when the VOX (Voice Operated Transmission) function is ON or the Break-in function is ON for the CW mode {pages 36, 39}.

uPROC

Appears when the Speech Processor function is ON {page 37}.

iMENU

Appears when configuring the parameters in the Menu mode {page 22}.

o

Reserved for future updates.

!0

Appears while the Constant Recording function is working {page 69}.

!1NB

Appears when the Noise Blanker is ON {page 47}.

!2AGC OFF

ÒAGC - FÓ (fast) or ÒAGCÓ (slow) appears when the AGC (Automatic Gain Control) function is ON. ÒAGC OFFÓ appears when the AGC is OFF {page 35}.

!3NAR 2

ÒNARÓ appears when the narrow IF filter is selected for the operating mode. If 2 optional IF filters are installed and the transceiver selects the secondary IF filter, ÒNAR 2Ó appears {page 45}.

!4MHz

Appears when the MHz Up/ Down mode using the MULTI control is ON {page 34}. It also appears when the Quick Menu function is ON {page 22}.

!5FINE

Appears when the Fine function is ON {page 35}.

!6

Appears when the selected Menu No. is in the Quick Menu list. It also appears when the transceiver is scanning the frequencies between the slow down frequency points {page 57}.

!7

Appears when the split-frequency operation is ON {page 30}.

!8

Appears when the Tuning control Lock function is ON {page 63}.

!9

Appears when the Frequency Lock function is ON {page 63}.

13

Page 21
Image 21
Kenwood TS-480SAT, TS-480HX instruction manual LCD Display, 2AGC OFF, 5FINE