Kenwood TS-480SAT, TS-480HX instruction manual Dwn, Power, Mode, Clr, Fast, Sync

13 OPERATOR CONVENIENCES

To switch the HF		Press [POWER].
transceiver OFF
To transmit audio on an		Press and hold the PTT
		switch, then speak into
HF frequency
		the microphone.
To receive audio on an		Press [RX].
HF frequency
To monitor the UHF band		Press and hold [MONI].
on the Commander
Key		Function
Tuning	Frequency or memory channel number
control	change
UP/	RIT offset or XIT offset change
DWN
A/B	In VFO mode: VFO A/ VFO B switch
	In Memory Recall mode: No change
POWER 1	Power ON/ OFF
RX 1	HF frequency receive ON/ OFF
MODE 1	Modulation mode switch
RIT 1	RIT ON/ OFF
XIT 1	XIT ON/ OFF
CLR 1	RIT offset or XIT offset clear
SPLIT 1	Split-frequency ON/ OFF
MsV 1	Transfer from Memory to VFO
FAST	In LSB, USB, or CW mode:
	10 Hz/ 1 kHz switch
	In FM or AM mode: 1 kHz/ 10 kHz switch
SYNC 1	Current settings retrieve
	(from HF transceiver)
ENT	In VFO mode: Frequency entry ON
	In Memory Recall mode: Channel
	number entry ON
M/V	VFO/ Memory Recall mode switch

1After pressing [ENT], you can use these keys as numeric keys to enter a frequency or memory channel number.

When [0/ SYNC] is pressed, the Commander shows the current settings of the TS-480 transceiver:

q	w
e	t

y r u

qHF frequency

wA (VFO A), B (VFO B),

00 ~ 99 (memory channel number)

eRIT, XIT

rOFF, Ð9.99 ~ +9.99

tÒFSÓ appears when [FAST] is ON. y LSB, USB, CW, FM, or AM

u SPLITÐA: VFO A is used for transmitting. SPLITÐB: VFO B is used for transmitting.

SPLITÐM: A memory channel is used for transmitting.

Note:

◆On the Transporter, only [LAMP], [MONI], and [MENU] will function. Pressing any other key will simply cause the Transporter to generate an error beep.

◆After pressing [MENU], you can access only Menu 4–4.

◆The Transporter will transmit its call sign in Morse code every 10 minutes, using the 144 MHz band.

◆The APO timer will not operate on the transceiver while the Transporter is ON.

75