Powering the unit
Word clock target
Video black burst source
Third party network
module
Network module A
Word clock source
DN9652 rear panel
Third party network
module
Network module B
Typical DN9652 audio connection configuration
Powering the unit
This section shows you how to connect the unit to the mains, switch the unit on/off and electrically isolate the unit.
The internal power supplies are of the switch mode type that automatically sense the incoming mains voltage and will work where the nominal voltage is in the range 100VAC to 240VAC.
>> To switch the unit on/off
Making sure that the mains power at the power outlet is off, connect the mains cable supplied with your DN965X to the mains power outlet and then to the mains socket at the rear of your unit. To switch the unit on/off, use the mains on/off switch on the rear of the unit. The blue KT roundel on the front of the unit will illuminate to show that power is on.
To electrically isolate the unit, switch it off and remove the mains cable from mains IEC socket on the rear panel.
DN9650/DN9652 Network Bridge |
|
Operator Manual | 3 |
