7ENG
Taking care of player and discsHandling of discs
- Please hold the disc by gripping the rim or by placing the index finger in the
central hole. Never touch the signal surface, which is shiny. This applies to
both sides of double sided discs.
- Never add labels or adhesive tapes on the discs and do not scratch or dam-
age the discs.
Cleaning of discs
- Finger prints or stains on the surface of the disc can cause signal missing.
Depending on the degree of stain, the reflected luminosity from the signal sur-
face may be weakened, resulting in a poorer picture quality. Therefore, please
use a soft cloth and wipe in a radiating manner from the centre to the outer
rims when cleaning the disc.
- If the surface of your disc is very dirty, please wipe the disc with a moist cloth,
finally use a dry soft cloth to remove all the water stains.
- Never use electrostatic prevention products as well as solutions which contain
benzene, thinner or any other vaporizing substances, as they may damage
the disc surface.
Storage of discs
- To prevent discs from getting bent or deformed, they should be vertically kept
in the disc storage case.
- To prevent damages, avoid placing them in a car, which may contact direct
sunlight. Also avoid leaving discs in excessively cold or humid environments.
- For more information refer to the instructions that come with discs.
Discs to avoid
Please only use conventional, fully circular discs in this DVD player. It is not rec-
ommended to use warped, cracked, chipped or otherwise damaged discs in
this device.
Disc accessories
Do not use any disc accessory to improve the audio quality, disc protective
solutions or lens cleaner. These products may cause problems.
Cleaning of the DVD player
The control panel and the case of the player will only require occasional wiping
with a soft cloth. Areas with stubborn stains can be cleaned with a soft cloth
dipped in a neutral detergent. To prevent damaging the player, never use vapor-
izing solutions.
INTRODUCTION
Labeling side
Labels
Tapes
Surface