Kodak 8657 manual Specifying Port Information, Setting up a Parallel Connection

Getting Started

Specifying Port Information

Use the SETUP:PORTS menu to change the default port information. Press the Setup/Select button to get into the SETUP:PORTS submenu. The options you select must match your host computer settings.

NOTE: The submenus that appear for this menu depend on whether the Network Interface Card is installed in the printer.

Setting up a Parallel Connection

Use the PORTS:PARALLEL menu to establish information about connecting the printer through a parallel port. The new option will be in place once you exit Setup mode.

PARA:MODEÐThis menu specifies whether the parallel port should accept data in normal PostScript mode or in Adobe binary mode. Normal PostScript mode can only support printable characters; it does not accept characters in the high ASCII range (128±255). Adobe binary mode supports the high ASCII range. Full 8-bit data may be sent.

The following settings are available.

MODE:NORMAL*

MODE:BINARY

MODE:EXIT

Select MODE:EXIT once you have made your selection, and PARA:EXIT when you are done.

January 1998 1±31