Service Manual | SM |
Safety Precaution
1. Do not operate or repair the projector without proper accessories. Add all COVERS before use to prevent mechanical hazards and electrical shock.
2. Before operating the projector, check the VOLTAGE SELECTOR. Make sure that the correct line voltage is selected.
3. Do not use a damaged POWER CORD. The damaged CORD can cause malfunctions and current leakage or electrical shock.
4. If there is any abnormal noise, smell or smoke during operation, deenergize the projector immediately and contact authorized personal for support.
5. Do not operate the projector in unsafe locations such as outdoors or in wet places. Do not allow liquids, gaseous or
6. When doing electrical measurements, use an isolation transformer or a leakage current detector in the power line to avoid an electrical shock.
7. Use only original parts from the Parts List to repair the projector.
8. Make sure that the requirements of UL 122 - Splices and Connection - paragraph 13.10 and EN 60 950, section 4.39 are observed. When replacing AC primary components, such as wires, sockets or capacitors , wrap the ends of the wire completely around the terminal before soldering.
03/98 | Kodak AG, Stuttgart |
