SM | Service Manual |
P-BUS
All the Models are equipped with the
The Models 4020 and 5020 has only an Input Bus, Models 7020 and 9020 and 9020/CINE an IN/OUT Bus.
The
figure
The purpose of the bus is to enable computer controlled projection with one or more slide projectors. Up to 16 different EKTAPRO 7020 or 9020 and 9020/CINE projectors can be addressed separately if they are connected through a daisy chain configuration. The projector addresses can be selected on the PROJECTORS ADDRESS SELECTOR SWITCH which is located above the
The
-1 Start bit
-8 Data bit
-1 Stop bit
-9600 Baud rate
-No Parity
The signal levels must be equal to the RS232 specifications.
The signal lines are only “Transmit Data” and “Receive Data”.
The projector can be controlled by other control signals beside the
The
Kodak AG, Stuttgart | 03/98 |