SM | Service Manual |
Slide Obstruction in Slide Tray
Conditions for a correct transport cycle
-Check SLIDE LIFTER LEVER. In the up position, the alignment above the CENTER HOUSING must be 3.8 mm (0.15 in.) with a tolerance of 0.2 mm (0.008 in.). If the measurement is greater, replace the SLIDE LIFT LEVER.
-Check the CENTER HOUSING for damaged parts such as:
DRIVE RING GEAR WHEELS CODER DISK
Inspect whether the parts are complete. Are there damaged or broken teeth on the wheels? If so, replace them.
Kodak AG, Stuttgart | 03/98 |
