Kodak 9020/CINE service manual Slide Change Sequence, Projector Status

SM 2547-1

Slide Change Sequence

Service Manual

Projector Status:

START

Close Shutter

Switch Autofocus Off

max. 805 Steps of Slide Lift Motor

CAM

Sensor Signal 0 - 1

?

Yes

Slide Lift Motor off

Start Tray Motion

Next slide position

Slide Lift Motor On

	CAM
	Sensor Signal
	1 - 0
	?
	Yes
No	Slide
	in Gate Sensor
	actuated
	?
	Yes

Switch on Autofocus

No

No

Slide Lift Motor off

Power LED blinking

Write Failure into

Memory

-	SLIDE LIFTER down
-	SHUTTER is open
- SLIDE is in GATE
-	LAMP is energized
Start:	“Forward”/"Reverse" BUTTON is pressed.
Signal from: P-Bus, Remote Control or Timer
The SHUTTER SOLENOID is deenergized.

The SLIDE LIFT MOTOR rotates clockwise to move the SLIDE LIFTER up (max. 805 steps = one SLIDE LIFTER cycle).

The SLIDE LIFTER is in the up position when the CAM SENSOR signal changes from not actuated to actuated.

If no:	the failure routine begins after 805 steps a without signal change.
If yes:	Starts the tray Motion. See page 3-10.

For details see page 3-10.

The SLIDE LIFT MOTOR moves clockwise to move SLIDE LIFTER down. The MOTOR stops when signal changes from actuated to not actuated.

Open Shutter

Yes TimerNo

activated

?

Projector does not operate

When a TIMER is in use, a slide advance forward is done each time after the selected interval is reached (Model´s 4020, 7020 external timer, Model 5020, 9020 and 9020/CINE internal timer).

End

figure 3-5

The slide is projected.

Kodak AG, Stuttgart 3-7 03/98