HOW TO INSTALL REFRIGERATOR
3. When customer uses bottled water.
*If customer wants to use bottled water, extra pump should be installed as shown below.
1.The pump system should not be on the floor (it may cause noise and vibration). Securely fasten the inlet and outlet nuts of pump.
2.If there is any leakage after installation, cut the water tube at right angle and reassemble.
3.When put the water tube end into the bottle, leave a clearance between bottle bottom and water tube end.
4 Check water coming out and any leakage.
Caution : • If feed tube is more than 4m, less water will come out due to pressure drops.
•Use standard feed tube to prevent leaking.
■Outternal Filter
1. Filter Fixation
1)There are two types of filter. One is nut type and the other is connector type.
2)Connect feed tube to the filter outlet and water valve connecting tube.
3)Fix the filter at proper place around the sink where it is easy to replace the filter and to receive the cleaning water. Please consider the length of tube shall be less than 8m when locating filter.
Nut
Water Tube | or |
| |
| Connector Type |
2. Filter Cleaning
Nut
Nut Type
InletOutlet
Hot Water
Cold Water
1)Connect feed tube to the inlet of feed valve and filter.
2)Clean the main valve and feed valve with water for at least one minute until clean water comes out.
Filter Inlet
Feed Valve
Filter
Water
- 13 -
