HOW TO DISASSEMBLE AND ASSEMBLE
4. WATER VALVE DISASSEMBLY METHOD
1)Turn off the power of the refrigerator (pull out the plug). Open the FREEZER and REFRIGERATOR Door and disassemble the Lower Cover.
2)Lay a dry towel on the floor and get ready to spill water from the water tank.
Pull out the Clip. Then press the collet to separate the tube from the connector and pour out the water until emptied.
(Refer to the label attached on Front L on how to separate the tube.)
InsertTubeLineColletClip
3)Turn off the water. Then separate the water line from the valve.
4). Separate the Mechanical Cover and Valve Screw.
Mechanical Cover
5)Separate the housing and pull out the valve.
Housing
5. FAN AND FAN MOTOR DISASSEMBLY METHOD
1)Using a short screwdriver, loosen one SCREW in DRAIN PIPE ASSEMBLY and one connected to the
MOTOR COVER.
DRAIN PIPE ASSEBLY |
| MOTOR COVER |
→
2)Pull and separate the FAN ASSEMBLY and MOTOR turning counterclockwise based on the MOTOR SHAFT.
FAN ASSEMBLY |
| MOTOR |
→
The assembly is in the reverse order of the disassembly and take special care for the following details.
1.Be careful not to bend the tube during assembly.
2.Press the WATER DISPENSER button until water pours out and check for leakage in the CONNECTOR TUBE (It differs by the water pressure but usually takes about 2 minutes until water pours out.)
- 86 -
