CLEARING THE DOCUMENT PATH
There are six (6) areas in the transport system where documents may become lodged:
AThe feeder/horizontal transport area
BThe imaging guide area
CThe lower roller assembly area
DThe vertical transport area
EThe upper turn area
FThe document exit area
•Check each transport area, in turn (Area A through Area F), for documents lodged in the document path. You only have to remove the jammed document(s). The jog feature places the rest of the documents
in the exit hopper.
NOTE: Make certain that all operator accessible areas (designated by green labels) are firmly closed and all baffle plates are locked into place.
•Press and hold down the JOG key to clear any remaining documents.
•Collect the documents located in the transport system. Put them back into their original order, if necessary.
•Reset the Image Address, Level, etc., if necessary.
•Refeed the documents.
If an error code appears in the Status Display, check each transport area again to make certain that all documents have been cleared.
|
