Scanner/Microimager 990: | Setup: | |
| √ Turn on main power switch, if necessary. | |
| √ Turn on side panel switch. | |
| √ Load film into cassette(s). | |
| √ Load film cassette(s) into machine. | |
| √ Select the lens holder position. | |
| √ | Select the mask. |
| √ | Calibrate the machine. |
√ Adjust the feed/separator rollers. √ Adjust the feed shelf.
√ Adjust the feed shelf length. √ Adjust the feeder side guides.
√ Adjust the exit hopper side guides. √ Adjust the exit hopper end stop.
√ Install the proper exit hopper deflector.
√ Perform an exposure step test, if necessary. √ Prepare documents to feed into transport.
Running a Job:
√Enable the machine from the host system.
√Select an application mode.
√Input any temporary/override operating values.
√Enter or verify the starting Image Address.
√Enter or verify the starting document image level.
√Press the Run key.
√Feed documents.
√Press the Stop key.
√Execute Scanner
√Remove documents from the exit hopper.
√Unload film cassette(s) from the machine.
√Unload film from the cassette(s), if necessary.
√Turn off side panel switch.
√Turn off main power switch, if necessary.
|
