Scanner 900 or Scanner 923: | Setup: |
| √ Turn on main power switch, if necessary. |
| √ Turn on side panel switch. |
| √ Calibrate the machine. |
| √ Adjust the feed/separator rollers. |
| √ Adjust the feed shelf. |
| √ Adjust the feeder side guides. |
| √ Adjust the exit hopper side guides. |
| √ Adjust the exit hopper end stop. |
| √ Install the proper exit hopper deflector. |
| √ Prepare documents to feed into transport. |
Running a Job:
√Enable the machine from the host system.
√Select an application mode.
√Input any temporary/override operating values.
√Enter or verify the starting Image Address.
√Enter or verify the starting document image level.
√Press the Run key.
√Feed documents.
√Press the Stop key.
√Execute Scanner
√Remove documents from the exit hopper.
√Turn off side panel switch.
√Turn off main power switch, if necessary.
|
