Energy Saving features of

Energy Star allows you to set the amount of time the scanner will

the scanner

remain inactive before the scanner goes into an idle state (sleep mode).

 

Choices are: 0 to 60 minutes.

Transport timeout

This feature allows you to set a transport timeout value. This value is

 

the amount of time the scanner will wait after the last document enters

 

the transport before the transport timeout action is taken. You can

 

specify a time delay setting from 1 to 300 seconds. The default is 10

 

seconds.

Blank image detection

Use the slider bar to specify the image size (KB), below which an image

 

is determined to be blank. Images with sizes less than the size number

 

you select will not be created. If you use this option, you must specify a

 

blank image size for each image type (Bi-tonal, Gray and Color) you

 

want to delete. The default for this option is None, which means that

 

you will keep all images.

Defining the Scan area

The Scan Area dialog box is only available for images when the

 

Cropping option selected on the Scanner Settings dialog box is either

 

Fixed to Transport or Relative to Document cropping.

 

To access the Scan Area dialog box, select Area on the ISIS Scanner

 

Settings window.

NOTE: Select the side and image to be defined by highlighting Front Color (Grayscale), Front Binary, Back Color (Grayscale), or Back Binary as appropriate based on the cropping option selected for each of these in the Scanner Settings dialog box. The scan areas defined for all camera selections are independent.

64

A-61512 May 2006

Page 67
Image 67
Kodak i30 / i40 manual Defining the Scan area