Konica Minolta C10 manual 180, Toner Incor

Symptom	Cause	Solution
Printing	The machine is set to	It takes more time to print with special
takes too	a slow printing mode	media. When using regular paper,
much time.	(for example, thick	make sure that the media type is set
	stock or transpar-	properly in the driver.
	ency).
	The machine is set to	It takes time for printing to start in
	power saving mode.	power saving mode.
	The job is very com-	Wait. No action needed.
	plex.
	A toner cartridge for a	Install a correct KONICA MINOLTA
	different region or an	toner cartridge approved for your spe-
	unapproved toner	cific machine.
	cartridge is installed
	(X TONER INCOR-
	RECT is displayed in
	the message win-
	dow).
Blank pages	One or more of the	Check the toner cartridges. The image
are printed.	toner cartridges are	will not print correctly or not at all, if the
	defective or empty.	cartridges are empty.
	The wrong media is	Check that the media type.
	being used.
Not all pages	The Cancel key was	Make sure no one pressed the Cancel
print.	pressed.	key while your job was printing.
	The tray is empty.	Check that the tray is loaded with
		media, in place, and secure.
	A document is printed	Print the overlay file using a bizhub
	with an overlay file	C10 printer driver.
	which has been cre-
	ated by a bizhub C10
	printer driver.
Some parts	If the Media type is	Press the + or , key to adjust the
of the image	Envelope and the	zoom ratio.
are lost with	zoom ratio for 2in1
2in1 copying.	copying will be less
	than 50%, the zoom
	ratio is set to 50%.

180 Solving Other Problems