Rear panel

1

2

3

 

 

 

 

 

 

4

5

6

7

8

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1.

~AC 9V

5. AUDIO IN jack

 

Connect the included AC/AC power supply to this

This jack lets you use an external audio source as

 

connector.

an oscillator. When the synth oscillator is set to

2.

STANDBY, ON (power switch)

AUDIO IN+COMB, the sound that is input here

will be used as the oscillator sound. This is a mon-

 

 

Pressing this switch will alternate between power-

on and standby conditions.

aural jack.

3. MIDI connectors

IN

This connector receives MIDI data. Use

 

this when you want to control the EMX-

 

1 from an external MIDI device, or to re-

 

ceive a data dump.

OUT

This connector transmits MIDI data. Use

 

this when you want to use the EMX-1 to

 

control another MIDI device, or to trans-

 

mit a data dump.

THRU

This connector re-transmits MIDI data

 

that was received at the MIDI IN con-

 

nector. Use this when you want to send

 

the same data to two or more MIDI de-

 

vices.

4. MIC, LINE gain select switch

This switches the gain level of the audio in jack. Set this to the MIC position if you are connecting a mic, or to the LINE position if you are connecting a synthesizer or audio device.

6. INDIV.OUT 3, 4 (individual out) jacks

These are individual output jacks. If the output bus of a part is set to 3/4, the sound of that part will be output from these jacks.

For all of the factory-set sounds, the output bus is

set to the line out jacks (L/R).

7. OUTPUT L/MONO, R (line out) jacks

Connect audio cables from these jacks to your mixer or powered monitor (amplified speaker) system. If you are using a monaural connection, use the L/MONO jack.

8. Headphone jack

You can connect a set of stereo headphones (phone plug) to this jack.

Front panel

1

Card section

1. SmartMediaTM slot

You can insert a SmartMedia card here and use it to store or load EMX-1 data.

14