Korg EMX-1 Playing a motion sequence, Checking motion sequence data

4. Pattern mode

If you press the STOP/CANCEL key to stop playback and then save the pattern as described in “Saving a pattern,” the motion sequence data you recorded will be saved together with the pattern.

You can record a maximum of twenty-four motion sequences in each pattern.

Playing a motion sequence

You can play back a motion sequence in one of the two modes described below.

The playback mode can be selected independently for each part.

Effect motion sequences will always play back using the SMOOTH mode of a part motion sequence. Motion sequences for an accent part will always play back using the TRIG HOLD mode.

AMP EG, ROLL, FX SELECT, FX SEND, MOD TYPE, MOD DEST, BPM SYNC, and SYNTH FILTER TYPE motion sequences will always play back using TRIG HOLD even if SMOOTH is selected.

SMOOTH: Knob movements will be played back smoothly, you will here the effect of the knob being turned even as a single note is sustained.

TRIG HOLD (trigger hold): Each new note being triggered will “hold” the motion sequence knob value as it was when the note was first triggered.

															Playback the motion sequence
															with Smooth setting
Knob movements when the motion
sequence was recorded
															1	2	3	4	5	6	7	8	9	10	11	12	13	14	15 16
															On			On		On On			On On			On		On
															Playback the motion sequence
															with Trig Hold setting
1	2	3	4	5	6	7	8	9	10	11	12	13	14	15 16
On			On		On On			On On			On		On
															1	2	3	4	5	6	7	8	9	10	11	12	13	14	15 16
															On			On		On On			On On			On		On

If the motion sequence LED is dark (off), this setting does nothing.

Checking motion sequence data

Here's how you can check and see what type of motion sequence data has been recorded. Hold down the shift key and press the motion sequence key of the part common section, and the step keys will light to indicate the motion sequence data that has been recorded. The display will indicate “FreeMot” and the number of remaining motion sequences that you can still record.

If a motion sequence is recorded for	The following key will light
Part Common section knobs	Step keys 1 and 2
Synth Filter section	Step key 3
Part Common section keys	Step key 4
Effect 1 motion sequence (Fx Edit 1 data)	Step key 5
Effect 1 motion sequence (Fx Edit 2 data)	Step key 6
Effect 2 motion sequence (Fx Edit 1 data)	Step key 7
Effect 2 motion sequence (Fx Edit 2 data)	Step key 8
Effect 3 motion sequence (Fx Edit 1 data)	Step key 9
Effect 3 motion sequence (Fx Edit 2 data)	Step key 10
Modulation knobs	Step key 11
Modulation keys	Step key 12
Synth oscillator OSC Edit 1	Step key 13
Synth oscillator OSC Edit 2	Step key 14

You cannot check the motion sequence data during playback or re-

cording, or while playing a pattern set.

59