Korg EMX-1 LPF, HPF, PITCH SHIFTER, EQ(Equalizer), (Pitch shifter), 4. Pattern mode, (Low Pass Filter), (High Pass Filter), DECIMATOR(Decimator), DISTORTION(Distortion)

PITCH SHIFTER	(Pitch shifter)
This effect modifies the pitch.
FX EDIT1: Pitch ..................................	-2400...+2400

Specifies the amount of pitch change in units of cents. When the knob is in the center position, the pitch of the input sound will not be changed. Turning the knob toward the left will lower the pitch, and toward the right will raise the pitch. The range is ±2 octaves.

FX EDIT2: Balance ......................................... 0...127

Adjusts the balance between the effect sound and direct sound. Turning the knob toward the right increases the effect sound and decreases the direct sound.

COMPRESSOR (Compressor)

A compressor boosts low-level sounds and reduces high-level sounds, decreasing variations in volume and making the sound more consistent. This compressor automatically detects the levels of the L and R input signals, and responds to the louder of the two.

FX EDIT1: Sens ..............................................	0...	127
(Sensitivity)
Adjusts the sensitivity of the compressor.
FX EDIT2: Attack ............................................	0...	127

Adjusts the speed at which the compressor begins to ap- ply. Turning the knob toward the right will slow down the attack.

DISTORTION(Distortion)

This effect drastically boosts the level to create distortion, producing a richer overtone structure.

FX EDIT1: Gain ............................................. 0...127

Adjusts the degree of distortion. Turning the knob toward

the right will produce more intense distortion.

FX EDIT2: Level .............................................. 0...127

Adjusts the output level. Turning the knob toward the right will increase the output level.

DECIMATOR(Decimator)

This effect decreases the sampling frequency and bit depth to give the sound a rougher character typical of inexpensive sam- plers.

FX EDIT1: Freq. ............................................. 0...127

(Sampling frequency)

Turning the knob toward the right will produce a “lo-fi” sound characteristic of a lower sampling frequency, and turning it toward the left will produce a “hi-fi” sound characteristic of a higher sampling frequency.

FX EDIT2: Bit ................................................. 0...127

(Sample bit depth)

Turning the knob toward the right will produce a “lo-fi” sound characteristic of a lower bit depth, and turning it

4. Pattern mode

toward the left will produce a “hi-fi” sound characteristic

of a higher bit depth.

If the input volume is very low, there may be no

audio output at all.

EQ(Equalizer)

This equalizer boosts/cuts the low and high-frequency regions

of the sound.

FX EDIT1: LowGain ...................................... -63...63

The volume of the low-frequency region will be cut when the knob is turned toward the left, flat when the knob is in the center position, and boosted when the knob is turned toward the right.

FX EDIT2: HighGain .................................... -63...63

The volume of the high-frequency region will be cut when the knob is turned toward the left, flat when the knob is in the center position, and boosted when the knob is turned toward the right.

For some input sounds, high gain settings may

cause distortion.

LPF (Low Pass Filter)

This is a low pass filter with resonance.

FX EDIT1: Cutoff ............................................ 0...127

Adjusts the cutoff frequency of the low pass filter. Turning the knob toward the right will raise the cutoff fre- quency.

FX EDIT2: Resonance ..................................... 0...127

Boosts the region of the cutoff frequency, giving the sound a distinctive character. Turning the knob toward the right will increase the resonance.

	High resonance settings may cause distortion de-
	pending on the cutoff frequency and the input
	sound.
HPF	(High Pass Filter)

This is a high pass filter with resonance.

FX EDIT1: Cutoff ............................................ 0...127

Adjusts the cutoff frequency of the high pass filter. Turning the knob toward the right will raise the cutoff fre- quency.

FX EDIT2: Resonance ..................................... 0...127

Boosts the region of the cutoff frequency, giving the sound a distinctive character. Turning the knob toward the right will increase the resonance.

High resonance settings may cause distortion de-

pending on the cutoff frequency and the input

sound.

45