3.Turn the dial to set the roll type.

You cannot apply a roll to note-on data from an external MIDI de-

vice.

Assigning the output of each part

OUTPUT BUS .............................................................

L/R, 3/4

For each part, you can route the sound to the line out jacks (L/ MONO, R) or to the individual out jacks (3, 4).

1.Press the PART EDIT key (it will light).

2. Use the [ ]/[ ] cursor keys to select “OutBus” in the parameter display. The “ ” symbols at the bottom of the screen indicate the output destination of each part.

3.Press the part key for the part that you want to set, and turn the dial to select either L/R (lit) or 3/4 (dark).

When you execute the Clear Pattern operation, OUTPUT BUS will

be set to “L/R” for all parts.

Adding distortion to increase the impact of the sound

TUBE GAIN ............................................................................

This adjusts the level at which the output signal from the line out jacks will be passed through the vacuum tubes. Even if you turn down the master control, you can use the TUBE GAIN knob to adjust the amount of distortion.

This strengthens the distortion produced by the vacuum tube.

Raising the TUBE GAIN knob excessively may damage your external speaker system. Please use caution.

This has no effect on the sound that is sent from the individual out jacks (3, 4).

26