
3. Basic operation
Preparations
Connections
AC
PHONES
MIXER etc.
1.Connect the included AC/AC power supply to the
2.Connect audio cables from the
3.If you are using headphones, plug them into the headphone jack.
Sound will still be output from the line out jacks even if headphones are plugged in.
Turning the power on/off
To turn the power on
1.Check the connections
2.Turn on the power switch.
3.Slightly turn up the
4.Adjust the
After you turn on the power, it will take approximately one minute before the vacuum tubes reach a stable state of operation. During this time, the output sound may be distorted even if the TUBE GAIN knob is turned down.
To turn the power off
1.Turn down the master volume to the minimum position. Also minimize the volume on your connected equipment.
2.Make sure that the card indicator in the display is not lit.
3.Set the power switch to the standby position.
If you will not be using the
You must turn off the power before making any connections. Careless operation can damage your speaker system or other equipment, and may cause malfunctions.
You must first connect the AC/AC power supply to the
17