The pattern and song data with which the
When you do this, the patterns or songs you created will be erased, and replaced by the preload data. If you want to keep the patterns or songs you created, you must save them to SmartMedia first.
1.While simultaneously holding down the Transpose key (Solo key) and the Write key, turn on the power.
2.The display will indicate “Preload,” and the PLAY/ PAUSE key will blink.
3.If you want to load the preload data, press the blink- ing PLAY/PAUSE key.
It will take approximately 30 seconds for the data to be loaded.
If you decide to cancel before executing, press the STOP/CANCEL key.
When loading is completed the
“A01.”
Never turn off the power while data is being loaded.
Doing so may destroy the data.
8. Appendix
Specifications
Number of parts: 16 parts (5 synth parts, 9 drum parts, 1 synth accent part, 1 drum accent part)
Memory capacity: 256 patterns, 64 songs
Effects:Three processors x 16 types
Sequences: Maximum of 128 steps per part.
Motion sequences: Total of 24 freely assignable sequences totaling
Song:Maximum of 256 patterns per song. Maximum 20,000 events for event recording.
Connectors**:
PHONES
Phone jack: stereo
Maximum output level: 16
Output impedance: 33 ohms
OUTPUT (L/MONO, R)
Phone jacks: mono x 2
Maximum output level: 0 dBu or more / TUBE
GAIN = min
Output impedance:
MONO)
Load impedance: 10
INDV.OUT (3, 4)
Phone jacks: mono x 2
Maximum output level: +7 dBu or more
Output impedance:
Load impedance: 10
INPUT (AUDIO IN)
Phone jack: mono (unbalanced)
Input impedance: 10
Maximum input level
(at LINE):
(at MIC):
Source impedance: 600 ohms
MIDI (IN, OUT, THRU)
| |
SmartMediaTM: | |
Vacuum tube: | 12AX7/ECC83 x 2 |
Power supply: | AC9V (included AC/AC power supply) |
Power consumption: | 23 W |
Dimensions: | 358 (W) x 256 (D) x 62 (H) mm (including the |
| rubber feet) |
Weight: | 3.1 kg |
**Analog specifications such as output levels are measured at the point where the vacuum tubes have stabilized af- ter
89