Special Analog Sources
The analog input sensitivity of the Audio +
Video Standard is set for the standard 2 Volts
that Dolby Laboratories mandates for proper
Dolby Pro Logic processing. For analog
sources (components connected to $1-$5
and tape) that do n~correspon.d to a stan-
dard 2 Volt output ~pecificationl, it may be
necessary to adjust individual input levels on
the Audio + Video Standard.
Press Menu to exit the menu system, select
the desired analog input and return to the
configure inputs menu.
Highlight SET ANALOG INPUT LEVEL and press
Enter. The set input .levels menu will appear:
- SET It~PUT LEVELS -
INPUT: B1
L R
- OVERLOAD -
LEVEL: 0 DB
OK
Begin playback of the selected source using
program material with loud passages. Press
Enter. The LEVEL dB specification will begin
blinking.
If the source unit’s output is greater than the
standard 2 Volts, OVERLOAD will blink indicat-
ing an input signal greater than standard.
Using the down scroll button, lower the level
db setting until OVERLOAD stops blinking. "
Conversely, if the source unit’s output .is less
than the standard 2 Volts, it will be necessary
to raise the input level sensitivity for proper
Doiby surround processing. Using the up
scroll button, raise the level dB setting until
OVERLOAD starts blinking and then reduce the
setting just below this threshold.
When the input level has been properly set,
highlight OK and press Enter to return to the
configure inputs menu. To adjust additional
inputs, exit the menu system by pressing
Menu, select the desired input, return to the
set input levels menu within the configure
inputs menu, and follow the same procedure
as above.
Linking a Video Input
to an Audio Input
Each video input (S-video and composite
video) may be linked to a specific audio input
and surround mode. Therefore, when a
video input is configured and then selected,
its matching audio input and surround mode
will also engage. Highlight sET VIDEO INPUT
LINKS within the configure inputs menu and
press Enter. The set video input links menu
will appear:
KRELL A+V STANDARD
- SET VIDEO INPUT LINKS -
WHICH VIDEO INPUT LINKS
WOULD YOU LIKE TO SET?
S-VIDEO INPUTS
SVl SV2 SV3 SV4
COMPOSITE VIDEO INPUTS
CV1 CV2 CV3 CV4
Highlight any of the S-video or composite
video inputs and press Enter. A secondary
screen will appear:
Page 22 of 32 - English KNELL
® Audio + Video Standard