Installing the Acrylic Cover,continued
CONNECTINGTHE FLEX FOIL CABLE
To connectthe flex foil cable, follow the easy steps describedbelowandillustrated in Figure 2 on page8.
IMPOFITANT
Donot crimp the flex foil cable, either manually or with pliers or other tools. Crimpingwill dam- agethe flex foil cable andmakeff inoperable.
Usecare wheninserting the flex foil cable. Its edges can be sharp.
1.Locatethe flex foil cable(D) attachedto the acrylic coverandthe flex foil receptacle(E) on top of the KPS25sc. Makesure the flex foil receptacleis open(seedetail E.1).
2.Usingyour fingers, carefully align the flex foil cable(D) so that its tip is parallel to the openflex foil receptacle. Againusing your fingers, gently feed the flex foil cable (D) into the flex foil receptacleuntil the cable touches the rear of the receptacle (see detail E.2).
3.Closethe flex foil receptacleby sliding the sleeve toward the front of tl~e KPS25sc (see detail E.3). There will be an audible click whenthe flex foil cable locks into the closedposition (seedetail E.4).
4.Recheckthat the flex foil cable~s curvedbut not crimped.
Theacrylic cover is nowreadyfor operation.
ADJUSTING THE COVER
CLOSING SPEED
Youcan adjust the cover closing speedusing the lid damperadjust screw (37) on the back panel. Adjustments can be madewhile the cover is up or down.
To decreasespeed, turn the screw clockwisein 1/8 inch increments.
To increase speed,turn the screwcoun- terclockwise in 1/8 inch increments.
IMPORTANT
The lid damperadjust screwis very sensitive. Always support the cover while adjusting the screwto keepthe cover from closing too fast.
10 | Krell KPS25sc |
