Kyocera VMS200 manual Phone battery, Getting Started, Installing the battery, Charging the battery

1GETTING STARTED

Phone battery

Installing the battery

To install the battery:

1.With the back of the phone facing you, locate the notch near the bottom of the phone.

2.With your thumbnail in the notch, lift up on the back cover to remove it.

3.Place the battery in the phone casing with the metal contacts toward the top of the phone.

4.Replace the back cover and press to snap it into place.

Note: Before removing the battery, make sure the phone is turned off.

Charging the battery

You must have at least a partial charge in the battery to make or receive calls.

To charge the battery:

1. Connect the AC adapter to the jack on the side

of the phone.

2. Plug the adapter into a wall outlet.

The battery icon on the right side of the external screen shows whether the phone is:

•Charging (animated icon)

•Partially charged

•Fully charged

Warning: The battery does not charge if you are in a call while it is connected to an AC adapter.

Recharging the battery

You can safely recharge the battery at any time, even if it has a partial charge.

User Guide 1