Lanier 5813 manual 163

Designating Areas

Notes for Designating Areas

The number of the points, areas, and groups that can be designated

Note

❒ Maximum number of points: 500

❒ In Right Angle Polygon mode, Polygon mode, or Line mode, the maximum number of points for one area is 30.

❒ The number of areas that can be designated is as follows:

• Rectangle mode: maximum 250 areas

• Right Angle Polygon mode, Polygon mode, Line mode: 500 points maxi- mum. For example, if 10 points are designated for each area, the maximum number of areas that can be designated is 50.

• Closed Loop mode, Multi-Closed Loop mode: maximum 500 areas
	5
❒ Maximum number of groups: 20 (multiple areas of the image that you wish

to apply the same effects to are referred to as a “Group”)

❒If you want to designate area shape like an acute angle by using Polygon mode or Line mode, see the following instructions.

•Use two separate lines to create angle(A).

•The first designated point(1) and the next designate point(3) should have distance of more than 4mm(0.2")(B).

*:4mm(0.2”)

Note

❒Do not designate an area or line which overlaps part of another area or line. If an area overlaps another one, the job settings specified last will be applied to the overlapped portion. As a result, those areas might not be copied.

163