Lenovo 2593, 2594, 2579, 2577, 2595, 2592 Front view of server models with 2.5-inch hard disk drives

Front view of server models with 2.5-inch hard disk drives

The following illustration shows the front view of server models with 2.5-inch hard disk drives.

Figure 6. Front view of server models with 2.5-inch hard disk drives

	2.5-inch hard disk drive area (right cage)		Rack handle (left)
1		5
	2.5-inch hard disk drive area (middle cage)		Diagnostic panel (varies by model)
2		6
	Pull-out information card		Front panel
3		7
	Slim optical drive (available in some models)		Rack handle (right)
4		8

1

2.5-inch hard disk drive area (right cage)

2

2.5-inch hard disk drive area (middle cage)

The front of server models with 2.5-inch hard disk drives consists of three cages:

•The left cage consists of the front panel board, the front VGA DB-15 connector, the diagnostic module, the pull-out information card, and the slim optical drive bay.

•The middle cage consists of the number 0 to number 7 hard disk drive bays. There is either a 2.5-inch hot-swap hard disk drive or a 2.5-inch dummy hard disk drive tray installed in each bay.

•The right cage consists of the number 8 to number 15 hard disk drive bays. There is either a 2.5-inch hot-swap hard disk drive or a 2.5-inch dummy hard disk drive tray installed in each bay. If the server supports up to eight hard disk drives, there will be an EMI-protective panel that covers the right cage as a whole.

Figure 7. Right cage with an EMI-protective panel

Note: The hard disk drive bay number (0-15) is marked above each 2.5-inch hard disk drive bay on the front bezel.

3

Pull-out information card

The machine type, model, and serial number label of the server is attached on the pull-out information card. See “Machine type, model, and serial number label” on page 14.

18ThinkServer User Guide