Lenovo RD540 manual Installing a hot-swap redundant power supply

Notes:

•Your hot-swap redundant power supply might look slightly different from the illustrations in this topic.

•Use any documentation that comes with the new hot-swap redundant power supply and follow those instructions in addition to the instructions in this topic.

To install a hot-swap redundant power supply, do the following:

1.Touch the static-protective package that contains the new hot-swap redundant power supply to any unpainted surface on the outside of the server. Then, take the new hot-swap redundant power supply out of the package.

2.Note the orientation of the new hot-swap redundant power supply and then slide the new hot-swap redundant power supply into the chassis until it snaps into position.

Figure 61. Installing a hot-swap redundant power supply

Chapter 6. Installing, removing, or replacing hardware 101