Lenovo TS200V manual Replacing the primary hard disk drive, Installation and User Guide

10.Connect the heat sink and fan assembly cable to the microprocessor fan connector on the system board. See “System-board internal connectors” on page 14.

What to do next:

vTo work with another piece of hardware, go to the appropriate section.

vTo complete the replacement, go to “Completing the parts replacement” on page 44.

Replacing the primary hard disk drive

Attention

Do not open your server or attempt any repair before reading and understanding the “Safety” on page v and the Safety Information book. To obtain a copy of the Safety Information book, go to: http://www.lenovo.com/support

This section provides instructions on how to replace the primary hard disk drive.

To replace the primary hard disk drive, do the following:

1.Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the server.

2.Remove the server cover. See “Removing the server cover” on page 18.

3.Locate the primary hard disk drive. See “Internal drives” on page 16.

4.Disconnect the signal cable and the power cable from the rear of the hard disk drive.

36Installation and User Guide