Lenovo TS200V manual Server setup roadmap, Task, Where to find information

Chapter 2. Server setup roadmap

The installation process varies depending on the configuration of the server when it was delivered. In some cases, the server is fully configured and just needs to be connected to power and the network and started. In other cases, the server needs to have hardware features installed, requires hardware and firmware configuration, and requires the operating system to be installed.

Table 1. Server setup roadmap

Task	Where to find information
Unpack	Chapter 3, “What is included with your server,” on page 7
Install hardware	Chapter 5, “Installing or replacing customer replaceable units,” on
features	page 17
Connect Ethernet cable	“Rear view” on page 12
and power cords to
network and power
connectors
Review Unified	“Using the Setup Utility program” on page 49
Extensible Firmware
Interface (UEFI)
settings and customize
as needed
Configure RAID	“Configuring RAID” on page 52
Check for firmware	Go to http://www.lenovo.com/support and go to the Downloads
updates	and Drivers section for this product.
Install operating	“Using the ThinkServer EasyStartup program” on page 56
system and basic
drivers
Install any additional	Refer to the instructions that came with the hardware option.
drivers needed for
added features
Configure Ethernet	See the operating system help. This step is not required if the
settings in operating	operating system was installed using the ThinkServer EasyStartup
system	program.
Install remote	“Installing ThinkServer EasyManage Agent” on page 58
management
applications
Install applications	Refer to the documentation that accompanies the applications that
	you want to install.

© Copyright Lenovo 2010 5