Lenovo TS200V Opening the retaining clips, Removing a memory module, Installation and User Guide

To install or replace a memory module, do the following:

1.Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the server.

2.Remove the server cover. See “Removing the server cover” on page 18.

3.Lay the server on its side for easier access to the system board.

4.Locate the memory slots. See “System-board internal connectors” on page 14.

5.Remove any parts that might prevent your access to the memory slots.

Note: Depending on your server model, you might need to remove the PCI Express x16 card for easier access to the memory slots. See “Installing or replacing a PCI card” on page 20.

6.If you are installing a new memory module, open the retaining clips of the memory slot into which you want to install the new memory module.

Figure 11. Opening the retaining clips

If you are replacing an old memory module, open the retaining clips and gently pull the memory module out of the memory slot.

Figure 12. Removing a memory module

24Installation and User Guide