10INSTALLATION
ENGLISH
Unpacking Your Refrigerator
WARNING
yUse two or more people to move and install the refrigerator. Failure to do so can result in back or other injury.
yYour refrigerator is heavy. When moving the refrig- erator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. Do not wiggle or walk the refrig- erator when trying to move it, as floor damage could occur.
yKeep flammable materials and vapors, such as gasoline, away from the refrigerator. Failure to do so can result in fire, explosion, or death.
Remove tape and any temporary labels from your refrigera- tor before using. Do not remove any
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily re- moved by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator.
Refrigerator shelves are installed in the shipping position. Please reinstall shelves according to your individual storage needs.
WARNING
To reduce the risk of electric shock, do not install the refrigerator in a wet or damp area.
Flooring
To avoid noise and vibration, the unit must be leveled and installed on a solidly constructed floor. If required, adjust the leveling legs to compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. Leveling legs can be turned easily by tipping the cabi- net slightly. Turn the leveling legs to the left to raise the unit or to the right to lower it. (See Leveling and door AlIgnment.)
NOTE
Installing on carpeting, soft tile surfaces, a platform or weakly supported structure is not recommended.
Ambient Temperature
Install this appliance in an area where the temperature is between 55°F (13°C) and 110°F (43°C). If the temperature around the appliance is too low or high, cooling ability may be adversely affected.
Measuring the Clearances
Too small of a distance from adjacent items may result in lowered freezing capability and increased electricity con- sumption charges. Allow at least 24 inches (61 cm) in front of the refrigerator to open the doors, and at least 2 inches (5.08 cm) between the back of the refrigerator and the wall.
Choosing the Proper Location
ySelect a place where a water supply can be easily con- nected for the automatic icemaker.
24” (61 cm)
NOTE
The water pressure must be between 20 and 120 psi on models without a water filter and between 40 and 120 psi on models with a water filter.
yThe refrigerator should always be plugged into its own individual properly grounded electrical outlet rated for 115 Volts, 60 Hz, AC only, and fused at 15 or 20 am- peres. This provides the best performance and also prevents overloading house wiring circuits which could cause a fire hazard from overheated wires. It is recom- mended that a separate circuit serving only this appli- ance be provided.
2” (5.08 cm)