ENGLISH
16INSTALLATION
6 Make sure that the | Removing the Freezer Drawers |
is tightly connected. Place the cover in its position and |
|
tighten the cover screw . | The top, middle and bottom drawers are all removed in the |
| same way. In the following figures, the Pullout Drawer |
| located above the freezer drawer is not shown for clarity. |
NOTE
Collet
Tube
Insert Line
Clip
1)Gently press the Collet and insert the tube until only one line shows on the tube.
CAUTION
yUse two or more people to remove and install the freezer drawer. Failure to do so can result in back or other injury.
yDo not hold the handle when removing or replac- ing the drawer. The handle may come off and it could cause personal injury.
yBe careful of sharp hinges on both sides of the drawer.
yWhen you lay the drawer down, be careful not to damage the floor.
yDo not sit or stand on the freezer drawer.
yTo prevent accidents, keep children and pets away from the drawer. Do not leave the drawer open.
If the Durabase® storage bin is removed from the freezer drawer, there is sufficient space inside for a small child or a pet to get into.
(Correct)
(Durabase®)
1 Pull the drawer open to full extension.
2 Lift up the basket and bin inside the drawer. (Images , in the figure below may differ from the actual
drawers of the refrigerator.)
(Incorrect)
2) Pull the tube to make sure that the tube is tightly fastened and then insert the clip.