Lindy PRO-300 Radio Frequency Energy and Compliance Declaration

Radio Frequency Energy and Compliance Declaration

A Category 5 (or better) twisted pair cable must be used to connect the LINDY Extender C5 units in order to

maintain compliance with radio frequency energy emission regulations and ensure a suitably high level of

immunity to electromagnetic disturbances.

All other interface cables used with this equipment must be shielded in order to maintain com pliance with radio

frequency energy emission regulations and ensure a suitably high level of immunity to electrom agnetic

disturbances.

European EMC directive 89/336/EEC

This equipment has been tested and found to comply with the limits for Information Technology Equipm ent in

accordance with the specifications in the European standard EN55022 and EN55024.

FCC Compliance Statement (United States)

This equipment generates, uses and can radiate radio frequency energy and if not installed and used properl y,

that is, in strict accordance with the manufacturer’s instructions, may cause int erference to radio communication

and television reception . It has been tested and found to comply with the limits for a class A computing device

in accordance with the specifications in Subpart J of part 15 of FCC rules, which are designed to provide

reasonable protection against such interference when the equipment is operated in a commer cial environment.

Operation of this equipment in a residential area may cause interference, in which case the user at hi s own

expense will be required to take whatever measures may be necessary to correct the interference.

However, there is no guarantee that harmful interference will not occur in a particular install ation. If this

equipment does cause interference to radio or television reception, which can be determi ned by turning the

equipment on and off, the user is encouraged to correct the interference with one or more of the following

measures: (a) Reorient or relocate the receiving antenna. (b) Increase the separation between the equi pment

and the receiver. (c) Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected. (d) Consult the supplier or an experienced radio / TV technician for help.

Changes or modifications not expressly approved by the manufacturer could void the user’s authori ty to operate

the equipment.

Canadian Department of Communications RFI statement

This equipment does not exceed the class A limits for radio noise emissions from digital apparat us set out in the

radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limit es applicables aux

appareils numériques de la classe A prescrites dans le règlement sur le brouillage radioél ectriques publié par le

ministère des Communications du Canada.

Tested to Comply with

FCC Standards

For Commercial Use