13.2 Learning a Single Sensor

Learn Sensor Mode may also be entered by pressing and holding the CANCEL button for fi ve seconds. The Console will announce:

0“Ready to learn sensor... Zone [number]”.

Activate the sensor to learn. The Console will announce:

0“[Fire, Activity, Emergency, or Carbon Monoxide] sensor learned”.

The Console will exit Learn Sensor Mode after learning one sensor. To exit without learning a sensor, press the CANCEL button.

13.3 Erasing All Sensors

To erase ALL sensors, press and hold TEST button for fi ve seconds. The Console will announce:

0“Zones reset”

All learned sensors are erased by this operation. The Console will then go to normal operation and announce:

0“Console ready”

NOTE: Any pending alarms or events for an erased zone will be cleared.

13.4 Testing Sensors

Each sensor learned into the Console should be tested. When a sensor is tested, the Console will announce the type of sensor, the zone number, and the RF signal level.

IMPORTANT! AFTER CONSOLE INSTALLATION, PORTABLE SENSORS SHOULD BE TESTED IN VARIOUS PLACES ON-LOCATION TO DETERMINE THE EFFECTIVE RADIO RANGE OF THE SYSTEM.

Use the following steps to test each system sensor.

1.Press and release the TEST button (located recessed on the bottom of the Console). The Console will announce:

0“Test Mode... firmware version [number]...

hardware version [number]”.

2.Activate each sensor to test. For each sensor, the Console will announce:

0“[Fire, Activity, Emergency, or Carbon Monoxide] sensor... zone [number]... [full or low] signal”.

If the sensor tested has a low battery, the Console will announce:

0“Sensor low battery... zone [number]”

3. When fi nished, press CANCEL to exit Test Mode (Test Mode will automatically exit after three minutes of inactivity).

"EMERGENCY SENSOR.... ZONE ONE... FULL SIGNAL"

 

PERS-4200

 

 

CONSOLE

 

 

IN TEST MODE

 

 

 

 

TEST ALL SENSORS

PRESS TEST BUTTON

 

PROGRAMMED INTO

 

THE CONSOLE

TO ENTER TEST MODE

 

 

 

IMPORTANT!

 

 

TEST SENSORS FROM VARIOUS

 

 

LOCATIONS IN THE INSTALLATION

 

BOTTOM OF

TO VERIFY THE EFFECTIVE RADIO RANGE

 

 

 

PERS-4200

 

 

CONSOLE

 

 

Testing System Sensors

30

Page 32
Image 32
Linear PERS-4200 Series manual Learning a Single Sensor, Erasing All Sensors, Testing Sensors