PrintServer for USB with 4-Port Switch
Chapter 5: Windows Driver Installation
Overview
This section installs the PrintServer’s software on your Windows 98, Me, 2000, or XP computers to give them PrintServer printing abilities. The PrintServer is fully compatible with Windows 98, Me, 2000, and XP.
At this point, you must have:
•the PrintServer hardware installed on your network. If not, see Chapter 3: Connecting the PrintServer.
•TCP/IP installed on each of your computers.
•an IP address assigned to each of the computers on your network..
•an IP address assigned to the PrintServer. By default the PrintServer has DHCP enabled. If you need to assign an IP address, go to Chapter 8:
•This setup should be completed on the network administrator’s computer before all other users’ computers on the network. The PrintServer’s IP address will be assigned in this first installation on the network administrator’s computer only, which takes three extra steps.
It is assumed that your
If you need to install the PrintServer’s driver on computers without a
Installation
1.If you haven’t already done so, insert the Setup
2.When you see Figure
Chapter 5: Windows Driver Installation
HAVE YOU: already set up your printer? Linksys recommends that you set up your printer and install your printer’s driver before you install the PrintServer’s driver.
Figure 5-1: Welcome
11
Overview