Configuration on Disk
Configuration on Disk (drive roaming) saves configuration information both in NVRAM on MegaRAID and on the disk drives connected to MegaRAID. If MegaRAID is replaced, the new MegaRAID controller can detect the actual RAID configuration, maintaining the integrity of the data on each drive, even if the drives have changed channel and/or target ID.
Hardware Requirements
MegaRAID can be installed in an IBM
Configuration Features
| Specification | Feature |
|
| RAID Levels | 0, 1, 3, 5, 10, 30, and 50 |
|
| SCSI Channels | 4 |
|
| Maximum number of drives per channel | 15 |
|
| Array interface to host |
| |
| PCI bus master | Supports write invalidate |
|
| Drive interface | Wide 160M |
|
| Upgradable cache memory sizes | 16 MB, 32 MB, 64 MB, or 128 |
|
|
| MB, |
|
| Cache Function |
| |
|
| NRA, RA |
|
| Multiple logical drives/arrays per controller | Up to 40 logical drives per controller |
|
| Maximum number of MegaRAID | 12 |
|
| controllers per system |
|
|
| Online capacity expansion | Yes |
|
| Dedicated and pool hot spare | Yes |
|
| Flashable firmware | Yes |
|
| Hot swap devices supported | Yes |
|
| Yes |
| |
| Mixed capacity hard disk drives | Yes |
|
| Number of | 2 |
|
| Number of external SCSI connectors | 4 |
|
| Support for hard disk drives with capacities | Yes |
|
| of more than 8 GB |
|
|
| Clustering support (Failover control) | Yes |
|
| Online RAID level migration | Yes |
|
| RAID remapping | Yes |
|
| No reboot necessary after expansion | Yes |
|
| More than 200 Qtags per physical drive | Yes |
|
| Hardware clustering support on the board | Yes |
|
| Yes |
| |
|
|
|
|
26MegaRAID Enterprise 1600 Hardware Guide