
Step 14 Install the Operating System Driver
Important
When booting the system from a drive connected to a MegaRAID controller and using EMM386.EXE, MEGASPI.SYS must be loaded in CONFIG.SYS before EMM386.EXE is loaded. If you do not do this, you cannot access the boot drive after EMM386 is loaded.
DOS ASPI Driver The MegaRAID DOS ASPI driver can be used under DOS, Windows 3.x, and Windows 95. The DOS ASPI driver supports:
•up to six
•up to six MegaRAID adapters (you should only configure one MegaRAID adapter per system if possible)
ASPI Driver The ASPI driver is MEGASPI.SYS. It supports disk drives, tape drives,
device=<path>\MEGASPI.SYS /v
Parameters The MEGASPI.SYS parameters are:
Parameter | Description |
/h | INT 13h support is not provided. |
/v | Verbose mode. All message are displayed on the screen. |
/a | Physical drive access mode. Permits direct access to physical drives. |
/q | Quiet mode. All message except error message are suppressed. |
Cont’d
72MegaRAID Enterprise 1600 Hardware Guide