Step 7 Set SCSI Terminator Power

J9, J10, J11, J12 These jumpers control TermPWR for the MegaRAID SCSI channels. See the documentation for each SCSI device for information about enabling TermPWR. The factory settings supply TermPWR from the PCI bus.

Important

The SCSI channels need Termination power to operate. If a channel is not being used and no auxiliary power source is connected, change the jumper setting for that channel to supply TermPWR from the PCI bus.

J9 SCSI Channel A – Short Pins 1-2 for PCI power.

J10 SCSI Channel B – Short Pins 1-2 for PCI power.

J11 SCSI Channel C – Short Pins 1-2 for PCI power.

J12 SCSI Channel D – Short Pins 1-2 for PCI power.

Chapter 6 Hardware Installation

61