15
This section provides the following information:
■Initial settings for the communications system and PARTNER Voice
Messaging when the PARTNER Voice Messaging PC Card is installed
■General instructions for programming PARTNER Voice Messaging followed
by instructions for changing the initial PARTNER Voice Messaging settings
The order of the procedures in this section enables you to record the general
mailbox greeting and change the assignments for the mailboxes before
PARTNER Voice Messaging begins to handle calls—this order is
recommended to ensure that calls are handled correctly for the subscribers
who require voice mail c overage.
In the following step-by-step instructions, note that Step 1 of each procedure
for the voice messaging system is logging into PARTNER Voice Messaging.
However, if you are already logged into PARTNER Voice Messaging, you can
skip Step 1.
Initial Settings
When the PARTNER Voice Messaging PC Card is installed in the PARTNER
ACS processor module (see “Installation Instructions” on page 12) and the
system is powered up, some settings are established for both PARTNER Voice
Messaging and the PARTNER ACS system.
If you want to make changes to the initial settings for PARTNER Voice
Messaging, use the instructions in “Using PARTNER Voice Messaging System
Programming” on page 18. If you want to make changes to the initial
PART NE R ACS settings, use the instructions in “PARTNER ACS Programming”
on page 26.
PARTNER Voice Messaging Programming