Lucent Technologies GW-DS300N manual Items Descriptions, ClickConnect

2. Open the configuration utility of GW-DS300N, the“Site Survey”

page displays several settings. The items and the setup instructions 2 are listed below. After opening the utility, the system will scan all the channels to find all the access points/stations within the accessible range

and automatically connect to one of the wireless APs which has the highest signal strength. The green icon which shows two hands holding together means GW-DS300N is connecting with the AP.

Items	Descriptions
SSID	The SSID (up to 32 printable ASCII characters)
	is a unique name identified in a WLAN. The SSID
	can prevent the unintentional merging of two
	co-located WLANs.
	You may assign an SSID for GW-DS300N, and only
	the device with the same SSID can interconnect to it.
BSSID	It displays the MAC Addresses of the APs which
	GW-DS300N has detected.
Signal	The box displays all the SSIDs (Service Set
	Identifier) and signal strength of the APs nearby. To
	detect the available wireless devices again please
	click“Rescan.”
	There are two ways to make a connection between
	GW-DS300N and one of the APs on the list:
	1.Double-click the wireless station on the list
	directly.
	2.Select the station you intend to connect and then
	click“Connect.”

19

Chapter 2 Basic Installation & Configuration