Magnavox H2160MW9 A owner manual Antenna Connection Required, Overview, Quality

CONNECTION

Read this first:

1)Disconnect the AC power cords of the devices from the AC outlet.

2)Make the connection as illustrated below.

3)After making all the connections, connect the AC power cords of the devices.

•Connect this unit directly to the TV. If the RCA audio/video cables are connected to a VCR, pictures may be distorted due to the copy protection system.

•When “Progressive Scan” is set to “ON”, no video signal will be output from the VIDEO OUT or S-VIDEO OUT jack.

Antenna Connection (Required)

Introduction Connections

rear of this unit

	VIDEO VIDEO			RF coaxial
IN		IN OUT	Y	cable
	L	L
OUT
	R	IN R	OUT	COAXIAL
ANTENNA	AUDIO IN	S-VIDEO AUDIO OUT	S-VIDEO	ANT. IN
	(L1)

This connection is for

TV loop through only

IN

OUT

ANTENNA

VHF / UHF

antenna

or

RF coaxial

cablecable TV company

Basic Setup Recording

Choose one of the following connections depending on the jacks on your TV.

Note

•For your safety and to avoid damage to the device, please unplug the RF coaxial cable from the ANTENNA IN jack before moving the unit.

•If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than set-top versions.

•ANTENNA OUT jack is for tuner pass through only. HDD / DVD playback through the RF is not possible.

Supplied cables used in this connection are as follows:

• RF coaxial cable x 1

Please purchase the rest of the necessary cables at your local store.

Overview

	If Your TV has		Refer to
Higher	HDMI IN		page
Quality				If you are using	page
			18
				cable / satellite box	19
			page
	COMPONENT VIDEO IN		17
			page	If your device has
				only an ANT. IN jack
			17
	S-VIDEO IN
			page		page
Standard	R	L		ANT. IN	20
			16

Quality AUDIO IN VIDEO IN

Playback

Editing Function Setup Others

Español

EN 15