Manitowoc Ice 11M manual Safe Installation Dos and Don’ts, Section

Installation Section 2

Safe Installation Dos and Don’ts

!Warning

Read the following warnings before beginning an installation. Failure to do so may result in possible death or serious injury.

•DO adhere to all National and Local Plumbing and Electrical Safety Codes.

•DO turn OFF incoming electrical service switches when servicing, installing, or repairing equipment.

•DO check that all flare fittings are tight. This check must be performed with a wrench to ensure a quality seal.

•DO inspect pressure on regulators before starting up equipment.

•DO protect eyes when working around refrigerants.

•DO use caution when handling metal surface edges of all equipment.

•DO handle CO2 cylinders and gauges with care. Secure cylinders properly against abrasion.

•DO store CO2 cylinder(s) in well ventilated areas.

•DO NOT exhaust CO2 gas (example: syrup pump) into an enclosed area, including all types of walk-in coolers, cellars, and closets.

•DO NOT throw or drop a CO2 cylinder. Secure the cylinder(s) in an upright position with a chain.

•DO NOT connect the CO2 cylinder(s) directly to the product container. Doing so will result in an explosion causing possible death or injury. It is best to connect the CO2 cylinder(s) to a regulator(s).

•DO NOT store CO2 cylinders in temperature above 125°F (51.7°C) near furnaces, radiator or sources of heat.

•DO NOT release CO2 gas from old cylinder.

•DO NOT touch refrigeration lines inside units; some may exceed temperatures of 200°F (93.3°C).

NOTICE: All utility connections and fixtures must be sized, installed, and maintained in accordance with Federal, State, and Local codes.

2-4 Part Number 020001552 5/11