ENGLISH |
| REAR PANEL |
|
|
|
|
|
| |
|
| q w | e r t y u | i |
|
|
|
|
|
|
|
| INPUT 1(TV) | INPUT 2(DVD) |
|
|
|
|
|
|
|
|
| SURROUND | SPEAKER |
|
|
|
| OUTPUT | MODEL NO. SR6001 | BACK | SYSTEMS |
|
|
|
|
|
| L | L |
FM (75) | GND | AM | ANTENNA |
|
|
| FRONT |
|
|
|
|
|
|
| A |
|
|
|
|
| COMPONENT | Y | CB/PB | CR/PR | Y | CB/PB | CR/PR | Y | CB/PB | CR/PR |
|
|
| |
|
|
|
|
| VIDEO |
| INPUT 3(VCR) | INPUT 4(DSS) |
|
|
| R | R | |||||
@2 |
| INPUT 1(DVD) | INPUT 2(DSS) |
|
|
|
| OUTPUT |
|
|
|
|
|
|
|
| ||
|
|
|
| HDMI |
|
|
|
|
|
|
|
|
|
| / SPEAKER C |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| MULTI SPEAKER |
| ||
|
|
|
|
| Ver1.2 |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| XM | AC IN | L |
| TV(1) |
| DVD(2) | VCR(3) | DSS(4) | MONITOR |
|
| TV(1) | DVD(2) | VCR(3) | DSS(4) | MONI. OUT |
|
| FRONT | ||
|
|
| IN | OUT |
| OUT |
|
|
|
|
|
|
|
|
|
|
| |
@1 VIDEO |
|
|
|
|
|
|
|
|
|
|
|
|
| B | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| R | ||
|
|
|
|
|
|
|
|
| IN | OUT |
|
|
|
|
| |||
|
| DIGITAL IN | DIGITAL OUT | DC OUT |
|
|
| L | SL | SBL | C | ON |
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
@0 | 4 | 5 |
|
| COAX. |
|
| IN |
|
|
|
|
|
|
|
| OFF | CEN |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| TER | |
|
|
|
|
|
|
|
|
| FLASHER |
|
|
|
|
| PRE |
|
| |
|
|
|
|
|
|
|
|
| IN |
|
|
|
|
| OUT | UNSWITCHED |
| |
1 | 2 | 3 |
| OPT. |
|
|
|
|
|
|
|
|
|
|
| 1.25A 150W |
| |
|
|
|
|
|
|
|
| OUT |
|
|
|
|
|
|
|
|
| L |
|
|
|
|
|
|
|
|
|
|
|
|
| R | SR | SBR | SW |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
| TV |
| DVD | VCR | DSS |
|
| TAPE | MULTI |
| L | SL | SBL | C |
| SURR | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| OUND |
!9 | L |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
R |
|
|
|
|
|
|
|
|
|
|
|
|
|
| 7.1CH |
| R | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| IN |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| SWITCHED | FRONT A OR B.CENTER.SURR. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 1.25A 150W | SURR BACK : 6 - 8 OHMS |
|
|
| IN | OUT |
|
| IN | OUT | IN | OUT | OUT |
| R | SR | SBR | SW | AC OUTLETS | FRONT A + B : 8 OHMS |
|
|
|
|
|
|
| AUDIO |
|
|
|
| (AUX2) |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| 120V 60Hz |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| !8!7!6!5 |
| !4 !3!2!1 !0o |
| ||||||||||
uSpeaker outputs terminals
(SURROUND BACK / MULTI
SPEAKER / SPEAKER C)
Two terminals are provided for the front left, and right speakers for multi room (2nd zone) or surround back.
The terminals can be used to connect a third set of speakers by setting the SPEAKER C selector switch to ON. For connection and use, see page 24.
iSpeaker outputs terminals
Seven terminals are provided for the front (A) left, front (A) right, front (B) left, front (B) right, front center, surround left, and surround right speakers.
oSPEAKER C switch
Set to ON to connect a
!0AC OUTLETS
Connect the AC power cables of components such as a DVD and CD player to these outlets. SWITCHED and UNSWITCHED outlets are provided.
!2Preamp Outputs
(L, R, SL, SR, SBL, SBR, C)
Jacks for L (front left), R (front right), C (Center), SL (surround left), SR (surround right), SBL (surround back left) and SBR (surround back right).
Use these jacks for connection to external power amplifiers.
!3Subwoofer Output
Connect this jack to the line level input of a powered subwoofer. If an external subwoofer amplifier is used, connect this jack to the subwoofer amplifi er input. If you are using two subwoofers, either powered or with a 2 channel subwoofer amplifier, connect a “Y” connector to the subwoofer output jack and run one cable from it to each subwoofer amplifier.
!47.1 CHANNEL or AUX2 INPUT
By connecting a DVD Audio player, Super Audio CD multichannel player, or other components that has a multichannel port, you can playback the audio with 5.1 channel or 7.1 channel outputs.
!5FLASHER IN (Flasher input terminal)
qFM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial cable, or a cable network FM source.
AM antenna and ground terminals
Connect the supplied AM loop antenna. Use the terminals marked “AM” and “GND”. The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best reception.
wCOMPONENT VIDEO INPUT/
OUTPUT
If your DVD player or other device has component video connectors, be sure to connect them to these component video connectors on the SR6001. The SR6001 has 4 component video input connectors to obtain the color information (Y, CB, CR) directly from the recorded DVD signal or other video component, and 1 component video output connector to output the information directly into the matrix decoder of the display device.
By sending the pure DVD component video signal directly, the DVD signal forgoes the extra processing that normally would degrade the image. The result is vastly increased image quality, with incredibly life like colors and crisp detail.
eMultiroom Output (Audio output)
This is the audio output jack for the Multi zone (Multi room).
Connect these jacks to optional audio power amplifiers to listen the source selected by the multiroom system in a remote room.
rMONITOR OUT
These are monitor outputs and each one includes both composite video and
t
The
The
yXM terminal
See page 23 for connecting information.
The one marked SWITCHED provides power only when the SR6001 is turned on and is useful for components which you use every time you play your system.
The one marked UNSWITCHED is always live as long as the SR6001 is plugged into a live outlet.
A component connected here may be left on permanently, or may be switched off with via its own power switch.
Caution:
•In order to avoid potential
•The capacity of this AC outlet is 150W. Do not connect devices that consume electricity more than the capacity of these AC outlets. If the total power consumption of the connected devices exceeds the capacity, the protection circuit shuts down the power supply.
!1AC INLET
Plug the supplied power cord into this AC INLET and then into the power outlet on the wall.
SR6001 can be powered by 120V AC only.
These terminals are to control the unit from each zone. Connect the control signal from a Keypad, etc.
!6DC TRIGGER output terminal
Connect a device that needs to be triggered by DC under certain conditions (screen, power strip, etc…) Use the system OSD setup menu to determine the conditions by which these jack will be active.
Note:
•This output voltage is for (status) control only, It is not sufficient for drive capability.
!7MULTI ROOM REMOTE IN/OUT terminals
IN: Connect to a
OUT: Connect to the Marantz component equipped with remote control
!8REMOTE CONT. IN/OUT terminals
Connect to a Marantz component equipped with remote control
8
