Preparing the Remote Controller

1.Open the Battery cover.

2.Insert two AA size batteries.

Make sure the polarities match the + and – marks inside the battery compartment.

3.Close the battery cover.

	CAUTION
	– The available battery types are limited: manganese dry cell
	and alkaline dry cell.
	– Do not mix different battery types.	ENGLISH
	– Do not mix old and new batteries.	ENGLISH
	– Do not mix old and new batteries.
	– Only batteries of the same type are to be used.
	– Remove exhausted batteries from the Remote Controller.
	– Do not attempt to recharge non-rechargeable batteries.
	– Do not use rechargeable batteries.
	– Batteries are to be inserted with the correct polarity.
	– The supply terminals are not to be short-circuited.
	– Never throw batteries in a fire or attempt to open up its outer
	casing.
	– If the user does not intend to use the Remote Controller for
	a long time, remove the batteries.
	– Keep away from heat.
	– The effect range of the Remote Controller is approximately
	6m.
	– Do not be subjected to strong shock.
	– Do not be subjected to moisture. If the unit gets moistured,
	wipe it off immediately.
	– The Remote Controller operation may not function if the
	projector’s IR sensors are exposed to direct sun light or
	strong artificial light, or if there is an obstacle between the
	IR sensors and the Remote Controller.

Remote Controller Operational Range

Operate the remote controller within a distance of approximately 5m from the IR sensor (remote sensor) on the projector. Remote control operation may not be possible if the remote control unit’s transmitter is not pointing in the direction of the remote sensor or if there is an obstruction between the transmitter and the remote sensor.

Remote

Controller

150