To Turn off the Power | Marantz VP-12S2 specs

To Turn off the Power

1.Press the STANDBY key on the remote controller or the POWER key on the projector.

2.The fan continues to run for a while to reduce internal heat. The POWER ON indicator flashes in blue and no key will be active. After about one minute of cooling has been done, the unit turns off and the STANDBY indicator lights up.

Notice : Do not pull out the AC power cord until the projector turns in standby mode.

Notice :

-Do not pull out the power cord suddenly in the state of “POWER ON." It can cause a breakdown.

-When a WARNING indicator lit up or blinks in red, pull out the AC power cord after checking that the fan has stopped.

-The projector will not be turned on if the POWER ON key on the remote controller or the POWER key on the projector is pressed immediately after turning off. Press the POWER ON key on the remote controller or POWER key on the projector after the projector turns into standby mode.

ENGLISH

19

Image 23

Marantz VP-12S2 manual To Turn off the Power

Contents

Model VP-12S2 User Guide For the customers in the USA Important Safety Instructions Table of Contents Replacement Important Safeguards Electronics & Software FeaturesOptics Accessories Projection Lens IR sensor Front and Top View Bottom View Rear and Terminals ViewTerminals ¡0THEATER key P.28 Remote Controller Remote Controller Operational Range Preparing the Remote Controller Connection When making connections be sure toWhen pulling out a cable Connection with AC Power Supply Advanced Connection Connection with a HD-Video, Satellite, Cable Tuner or PC Adjusting the Image Position Initial SettingTurning on the Power Zooming and Focusing Counterclockwise Down Adjusting the HeightDetail Focusing Returning the Projector to its Initial Position Keystone Correction Mounting on the ceiling InstallationRecommended Setting Installing on a tabletop Screen Screen Size and Projection Distance inch16 9 Screen Diagonal Width Height Minimum Maximum Inch Screen Size and Projection Distance m Basic Operations Selecting the Input Signal SourceSelecting the Aspect Mode Screen Images in a 169 screen Screen Images in a 43 screen To Turn off the Power Menu Structure Operations Color Temp. Temperature Using On-Screen MenuPicture Adjust Setting the Picture Adjust Menu Chrominance DelayFine Menu Luminance Miscellaneous Sub Control Setting the Setting Menu Setting Display Setting the Display Menu Configuration On Output DC Setting the Config MenuSetting the Trigger 2 Menu Trigger Lamp Life Setting the Memory MenuMemory Lamp Life and Replace Lamp Initialize the Lamp Life Replacing Lamp Unit MaintenanceHow to replace the Lamp Unit Optional Accessories Cleaning the LensReplacement Parts Error Mode Troubleshooting On Screen Message Specifications Glossary Timing chart Bottom DimensionsTop Front Is a registered trademark