™4USER button (☞ P.32)
Selects the user mode.
The user mode is for enjoying images at a
Every time the button is pressed, the selection rotates in the order of User A1 ➔ User A2 ➔ User A3 ➔ User B1 ➔ User B2
➔User B3 ➔ User C1 ➔ User C2 ➔ User C3.
For more information on how to select gamma curve ➔ (☞ P.32)
™5DYNA. button (☞ P.32)
Select the Dynamic picture mode.
Dynamic mode is good for visually dynamic pictures.
Every time the button is pressed, the selection rotates in the order of Dynamic 1 ➔ Dynamic 2 ➔ Dynamic 3 ➔ Default.
Remote Controller Operational Range
Operate the remote controller within a distance of approximately 5m from the IR sensor (remote sensor) on the projector.
Remote control operation may not be possible if the remote control unit’s transmitter is not pointing in the direction of the remote sensor or if there is an obstruction between the transmitter and the remote sensor.
|
| Remote |
|
| Controller |
| 150 |
|
5m | 60 |
|
Remote |
| |
Controller |
| |
|
| |
| 60 | 5m |
5m | 60 | Remote |
|
| |
Remote | Controller | |
|
Controller
Remote
Controller
5m
60
Preparing the Remote Controller
1. Take the cover off the battery case on the remote control |
| |
backside. | ENGLISH | |
Battery case cover | ||
|
2.Insert two AA size batteries.
Make sure the polarities match the + and – marks inside the battery compartment.
AAsize batteries
3.Reattach the battery case cover as before.
Battery case cover
CAUTION
–The available battery types are limited: manganese dry cell and alkaline dry cell.
–Do not mix different battery types.
–Do not mix old and new batteries.
–Only batteries of the same type are to be used.
–Remove exhausted batteries from the Remote Controller.
–Do not attempt to recharge
–Do not use rechargeable batteries.
–Batteries are to be inserted with the correct polarity.
–The supply terminals are not to be
–Never throw batteries in a fire or attempt to open up its outer casing.
–If the user does not intend to use the Remote Controller for a long time, remove the batteries.
–Keep away from heat.
–Do not be subjected to strong shock.
–Do not be subjected to moisture. If the unit gets moistured, wipe it off immediately.
–The Remote Controller operation may not function if the projector’s IR sensors are exposed to direct sun light or strong artificial light, or if there is an obstacle between the IR sensors and the Remote Controller.
7
